Monthly Archives: December 2014

AutoLISP: Make Perpendicular Line Between Two 3D Angles

Posted on December 18, 2014 by AutoCAD Tips

This Lisp was found at http://paulbourke.net/geometry/pointlineplane/int2.lsp and has been a great help in 3D and sometimes being off by a little bit can be very frustrating. You can always us the distance command and then look for the specific X distance or … Continue reading →

Posted in AutoLISP, AutoLISP: 3D, AutoLISP: Creating | 1 Comment

Navisworks – Update your DWG Loader Version

Posted on December 7, 2014 by AutoCAD Tips

When you update AutoCAD and/or Navisworks and then try to open your your drawing in Navisworks, you might run into issues. One thing to check is making sure that the version of AutoCAD that created the DWG is set correctly … Continue reading →

Posted in Navisworks | Leave a comment

Making CADWorx Piping Intelligence Display in Navisworks

Posted on December 4, 2014 by AutoCAD Tips

When you upgrade your version of Navisworks, you want to be able to hover over a piping component from CADWorx and have certain CADWorx properties display near your cursor. Today’s tip describes this. From the Home Tab of the ribbon, … Continue reading →

Posted in CADWorx, Navisworks | 2 Comments