Monthly Archives: November 2014

Tip for Autodesk University Attendees

Posted on November 29, 2014 by AutoCAD Tips

Last year on Twitter, I posted this simple tip for those attending AU and since I am luck enough to be going this year I want to stress the importance of the tip from last year. Tip: LOOK UP AND … Continue reading →

Posted in TIPS | 6 Comments

AutoCAD 2015 Tray Settings for Print Pop-Up

Posted on November 18, 2014 by AutoCAD Tips

After you print in AutoCAD, there is a little annoying notification that stays open in the bottom right of the screen until you click to close it. This is the default setting. This setting can be changed so that it stays … Continue reading →

Posted in BASICS, Customization, New in 2015, Printing - Plotting, TIPS | 2 Comments

AutoLISP: Updated Heal Line/Polyline

Posted on November 12, 2014 by AutoCAD Tips

There were 2 posts from a while back that did the same thing – Erase a selected block and then heal the LINE or POLYLINE, but the annoying thing was that only one routine would work for LINES and you … Continue reading →

Posted in AutoLISP, AutoLISP: Blocks, AutoLISP: Modify, AutoLISP: Polylines, Modifying, Uncategorized | 2 Comments