If you need to erase an individual wipeout, there is a command that is a “toggle” which means that once the command is entered, it either turns this function on or off. The command is TFRAMES. there is no button for it on the ribbon or on a toolbar so you have to use the command. This command makes the wipeout frames (outlines) visible and thus selectable so that you can erase them.
To start:
- TFRAMES <enter>
- (make sure to check the command line as it will tell you whether you are in fact turning them on or off)
- With “Selection Cycling” turned on, it is easy to select the wipeout (as seen below)
- After selecting the wipeout, hit the delete button or use the ERASE command